The EDC cap kit includes the world's lightest helmet top cap (4.2 g) and an EDC steering cap with drain hole that prevents dirt from entering your pivot.
Top caps are compatible with all 1-1/8" aluminum head tubes.
The EDC steering cap is required for storing EDC tools and is compatible with most tapered aluminum steering tubes.
KIT INCLUDES
- EDC TOP CAP
- EDC steering cap
- 2 helmet spacers 1 mm, 3 mm and 5 mm
INSTALLING THE EDC TOP CAP
- You need a minimum of 5 mm of headset spacer above the stem, and your head tube should be 1 to 2 mm below the top of this spacer.
- Apply a small amount of grease to your newly cut thread and screw on your new EDC top cap.
- The Top Cap interface uses a standard cassette locking tool. You don't need to apply much torque because you're only preloading the bearings. (Your stem clamp bolts are what hold your fork in place). The EDC multitasking tool contains a top cap tightening tool. So even when you're riding, you always have the option of tightening your headset if necessary.
- Align your stem and tighten your stem bolts to the torque recommended by the manufacturer.
- The final step is to insert the plastic plug/cap into the bottom of your fork. Turn your 8 mm hexagon sideways and use it to push the plug into the fork, pulling the 8 mm towards your chest. This piece holds the bottom of the EDC tool and prevents it from rattling. It also prevents dirt from entering your fork and has a small drain hole.
Note
* The EDC Tap kit includes a star nut extractor and a self-aligning tap
The information below is required for social login